VoIP: Configuration:

Eyebeam

Following article describes how to configure your Eyebeam softphone for use with BroadTelephone PC 2 Phone service.

Installing Eyebeam for Windows:

To begin installing the Eyebeam phone, double-click the installation file on your desktop. Simply read the instructions and continue clicking next until you reach a page with a series of check boxes. It is recommended that you select both "Create a desktop icon" and "Launch the application when Windows starts."

Press "Install" on the next screen. After the process has completed, check the box that says "Launch Eyebeam." You are now ready to configure your phone with the instructions below.

Configuring Eyebeam:

After installing and running the Eyebeam software for the first time the SIP Account Settings menu shown below should appear automatically.

If the settings menu does not appear, or to reach this menu any time in the future, right click on the softphone anywhere and then click on 'Settings'

Enter the values as shown below. The Ten Digit Number to use is the full Ten Digit Number assigned to you. The password field will need to contain the SureRing assigned password necessary for the phone to register.

After filling in the fields click OK to close out of the SIP Account Settings menu. The softphone should display "Logged in" at the very top of the display as well as "Your number is:" and your phone number. The phone is now registered and ready to make calls